Filters
Question type

Study Flashcards

The electronic (halogen)leak detector is the most expensive and sensitive of all leak detection devices.

Correct Answer

verifed

verified

Technician A says that the electronic leak detector probe should be held directly against a suspected leak area during a eak test.Technician B says that the electronic leak detector requires routine calibration and probe tip inspection and maintenance.Who is correct?


A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Correct Answer

verifed

verified

B

Refrigeration oil circulates with the refrigerant through the system.

Correct Answer

verifed

verified

When making system repairs,install the receiver-drier or accumulator


A) first.
B) last.
C) after evacuating the system.
D) any time.

Correct Answer

verifed

verified

All of the following statements about system evacuation are true,EXCEPT:


A) Water boils at a lower temperature at higher altitudes.
B) Vacuum pump efficiency is increased at higher altitudes.
C) At high altitudes, ambient temperature must be raised for the vacuum pump to efficiently remove moisture.
D) Running the vehicle engine will raise the temperature of the underhood components.

Correct Answer

verifed

verified

Technician A says the performance test is a way of measuring system pressures.Technician B says the performance test is a way of measuring the outside humidity.Who is correct?


A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Correct Answer

verifed

verified

A

List popular methods of refrigerant leak detection.

Correct Answer

verifed

verified

Soap solutions,elect...

View Answer

Technician A says that the recommended oil for most R-134a systems is PAG oil.Technician B says that the recommended oil for R-12 systems is mineral-based oil.Who is correct?


A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Correct Answer

verifed

verified

Charging the system is being discussed.Technician Asays the refrigerant must be weighed (or metered) to obtain a proper charge.Technician B says overcharging the system will reduce its cooling efficiency.Who is correct?


A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Correct Answer

verifed

verified

Technician A says "intent to vent" means the technician is working in a shop without adequate ventilation.Technician B says "intent to vent" means the technician is working on an air conditioner in a shop that does not have a recovery machine for each type of refrigerant being serviced.Who is correct?


A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Correct Answer

verifed

verified

What two factors determine the amount of moisture removed from an air conditioning system?

Correct Answer

verifed

verified

The degree of vacuum...

View Answer

What is the minimum time a system should be evacuated for?

Correct Answer

verifed

verified

When servicing a Hybrid vehicles refrigerant system it is imperative that the correct what be used in the refrigerant system?

Correct Answer

verifed

verified

When servicing a Hybrid vehicl...

View Answer

What are the sources of refrigerant system contamination?

Correct Answer

verifed

verified

Cross-contamination by another...

View Answer

Explain why recharging the air conditioning system is the most important service procedure the technician will perform on the system.

Correct Answer

verifed

verified

An improperly charged system o...

View Answer

Explain when a soap solution should be used as a method of leak detection.

Correct Answer

verifed

verified

When it is impractical or impo...

View Answer

Most original equipment manufacturers use what type of lubricant in their R-134a systems?


A) Mineral
B) Ester
C) Paraffinc
D) PAG

Correct Answer

verifed

verified

C

Technician A says that the A/C system may be charge through the LOW side when the system is operating.Technician B says that the A/C system may be charged through the HIGH side when the system is off .Who is correct?


A) Technician A only
B) Technician B only
C) Both A and B
D) Neither A nor B

Correct Answer

verifed

verified

When evacuating the system,what position should all service valves and manifold gauge valves be in?

Correct Answer

verifed

verified

The pressure of the bulk recovery tank can be tested to identify refrigerant cross contamination.

Correct Answer

verifed

verified

Showing 1 - 20 of 51

Related Exams

Show Answer