Question 1

Which router port is used for dial-in access to the router for CLI management purposes and does not usually pass normal network traffic?

Accepted Answer

A)   Fast Ethernet
B)   channelized serial
C)   AUX
D)   Gigabit Ethernet

Question 2

Which Cisco CPAK 100GBASE module supports Multimode Fiber cable?

Accepted Answer

A)   Cisco CPAK-100G-CWDM4
B)   Cisco CPAK-100G-LR4
C)   Cisco CPAK-100G-ER4L
D)   Cisco CPAK-100G-SR4

Question 3

What are two components of a WAN connection? (Choose two.)

Accepted Answer

A)   CSU/DSU
B)   router
C)   bridge
D)   hub
E)   switch

Question 4

An Ethernet interface is up and the line protocol is down. What are two possible causes? (Choose two.)

Accepted Answer

A)   There is a speed or duplex mismatch with the remote device.
B)   There is a Layer 2 mismatch in the encapsulation type.
C)   The Ethernet interface has been manually disabled.
D)   Keepalives are not being received by the local device.
E)   The Ethernet cable might not be attached properly.

Question 5

Which command sends an echo request packet to the target host and then waits for an echo response message?

Accepted Answer

A)   echo
B)   access
C)   ping
D)   connect

Question 6

Which type of Cisco console cable is used to connect a laptop to the console port on a Cisco router?

Accepted Answer

A)   straight-through
B)   fiber
C)   crossover
D)   rollover

Question 7

From the enable mode, which command loads the configuration during the password recovery process on a Cisco router?

Accepted Answer

A)   load_helper
B)   configure terminal
C)   copy running-config startup-config
D)   copy startup-config running-config

Question 8

Which two IPv4 addresses can be assigned to a host computer? (Choose two.)

Accepted Answer

A)   255.255.255.255
B)   10.1.1.20
C)   0.0.0.0
D)   192.168.10.15
E)   292.10.3.4

Question 9

Which type of memory is used to permanently store Cisco IOS Software?

Accepted Answer

A)   NVRAM
B)   flash
C)   SRAM
D)   DRAM A

Question 10

What is the correct IPv6 address notation?

Accepted Answer

A)   2001:0DB8::/128
B)   2001:0DB8:0::
C)   2001:0DB8::1:1:1:1:1
D)   2001:0DB8:130F:0000:0000:7000:0000:140B

Question 11

What is the primary method for recovering or upgrading a Cisco network device system image?

Accepted Answer

A)   USB storage
B)   FTP
C)   the tftpdnld command the tftpdnld command
D)   the xmodem command xmodem C

Question 12

Which two commands are valid for copying a saved configuration to RAM? (Choose two.)

Accepted Answer

A)   copy startup-config running-config
B)   copy running-config startup-config
C)   copy tftp running-config
D)   copy running-config tftp
E)   copy tftp startup-config

Question 13

Which two ports on a laptop are used to gain console access to a Cisco switch? (Choose two.)

Accepted Answer

A)   DB-9
B)   USB
C)   DVI
D)   RJ-11
E)   RJ-45 Ethernet

Question 14

The pins on an RJ-45 cable plug are numbered from 1 through 8. When the metal pins of the plug are facing toward you, pin 1 is the leftmost pin. Which two sets of pins are looped on an RJ-45 56K loopback plug? (Choose two.)

Accepted Answer

A)   pins 2 and 7
B)   pins 2 and 8
C)   pins 2 and 5
D)   pins 1 and 7
E)   pins 1 and 4

Question 15

What does Cisco use for Return Materials Authorization tracking of field-replaceable parts?

Accepted Answer

A)   product number
B)   serial number
C)   RMA number
D)   FRU number

Question 16

What is the Windows-based program that executes the ping command to test network connectivity?

Accepted Answer

A)   cmd
B)   Find
C)   Start
D)   ipconfig A

Question 17

Which two pieces of information about a neighboring device are displayed when you use the CLI command show cdp neighbor? (Choose two.)

Accepted Answer

A)   platform
B)   uptime
C)   device ID
D)   Cisco IOS Software version
E)   IP address

Question 18

Which Windows-based text editor is preferred for working with a simple text document, such as a Cisco configuration?

Accepted Answer

A)   Microsoft Word
B)   Microsoft Notepad
C)   Microsoft Access
D)   Microsoft Excel

Question 19

Which type of port on a laptop is used to connect to an Ethernet port on a Cisco switch?

Accepted Answer

A)   DVI
B)   RJ-11
C)   DB-9
D)   RJ-45

Question 20

Which type of physical connector does a Gigabit Ethernet port typically use?

Accepted Answer

A)   RJ-9
B)   RJ-45
C)   DB-25
D)   RJ-11

Exam 2: Cisco Certified Technician Routing & Switching (RSTECH)

Which router port is used for dial-in access to the router for CLI management purposes and does not usually pass normal network traffic?

Correct AnswerverifiedShow Answer

Which Cisco CPAK 100GBASE module supports Multimode Fiber cable?

Correct AnswerverifiedShow Answer

What are two components of a WAN connection? (Choose two.)

Correct AnswerverifiedShow Answer

An Ethernet interface is up and the line protocol is down. What are two possible causes? (Choose two.)

Correct AnswerverifiedShow Answer

Which command sends an echo request packet to the target host and then waits for an echo response message?

Correct AnswerverifiedShow Answer

Which type of Cisco console cable is used to connect a laptop to the console port on a Cisco router?

Correct AnswerverifiedShow Answer

From the enable mode, which command loads the configuration during the password recovery process on a Cisco router?

Correct AnswerverifiedShow Answer

Which two IPv4 addresses can be assigned to a host computer? (Choose two.)

Correct AnswerverifiedShow Answer

Which type of memory is used to permanently store Cisco IOS Software?

Correct AnswerverifiedA

What is the correct IPv6 address notation?

Correct AnswerverifiedShow Answer

What is the primary method for recovering or upgrading a Cisco network device system image?

Correct AnswerverifiedC

Which two commands are valid for copying a saved configuration to RAM? (Choose two.)

Correct AnswerverifiedShow Answer

Which two ports on a laptop are used to gain console access to a Cisco switch? (Choose two.)

Correct AnswerverifiedShow Answer

The pins on an RJ-45 cable plug are numbered from 1 through 8. When the metal pins of the plug are facing toward you, pin 1 is the leftmost pin. Which two sets of pins are looped on an RJ-45 56K loopback plug? (Choose two.)

Correct AnswerverifiedShow Answer

What does Cisco use for Return Materials Authorization tracking of field-replaceable parts?

Correct AnswerverifiedShow Answer

What is the Windows-based program that executes the ping command to test network connectivity?

Correct AnswerverifiedA

Which two pieces of information about a neighboring device are displayed when you use the CLI command show cdp neighbor? (Choose two.)

Correct AnswerverifiedShow Answer

Which Windows-based text editor is preferred for working with a simple text document, such as a Cisco configuration?

Correct AnswerverifiedShow Answer

Which type of port on a laptop is used to connect to an Ethernet port on a Cisco switch?

Correct AnswerverifiedShow Answer

Which type of physical connector does a Gigabit Ethernet port typically use?

Correct AnswerverifiedShow Answer

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified
A

Correct Answer
verified

Correct Answer
verified
C

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified
A

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified

Correct Answer
verified