FiltersDone

Question type

Essay

Multiple Choice

Short Answer

True False

Matching

Exam 19: Service Panel Trim-Out

Show Answer

Share

---

All types

Filters

Study FlashcardsPractice ExamLearn

Question 21

Short Answer

Review LaterAdd Note

Review Later

The highest current at rated voltage that a device is intended to interrupt under standard test conditions is called the ____________________ rating.

Correct Answer

verified

Show Answer

Question 22

Essay

Review LaterAdd Note

Review Later

Explain what a hexagonal configuration on a plug fuse indicates.

Correct Answer

verified

The fuse i...

View Answer

Show Answer

Question 23

True/False

Review LaterAdd Note

The NEC permits overcurrent protection devices to be located in bathrooms.

When installing a two-pole circuit breaker to protect a two-wire Type NM cable feeding a 240 volt electric water heater, describe what needs to be done with the white conductor in the cable that will be terminated at the breaker.

Which of the following will not cause an overcurrent condition?

Fuseholders for current-limiting fuses can not permit the insertion of fuses that are not ______________________________.

Name an advantage to installing a multiwire circuit in residential wiring.

Explain how a 240-volt circuit is wired differently than a 120/240-volt circuit.

For circuit breakers, if the interrupting rating is different than ____________________ amperes, it must be marked on the breaker.

A GFCI or AFCI circuit breaker should be tested at least once a ___________.

A two-pole circuit breaker is used to protect a 120-volt branch circuit.

When installing an ungrounded conductor in a circuit breaker, approximately __________ of insulation is stripped from the end of the conductor.

The circuit breakers are attached to the bus bar by contacts in the breakers commonly called ____________________.

All circuit breakers must be designed so that any fault must be cleared before the circuit breaker can be ____________________.

A(n) __________ fuse uses different fuse bases for each size fuse and an adapter that matches each fuse size is required.

Type S fuses are classified at __________ amperes.

Overcurrent protection devices must be readily accessible.

A(n) __________ fuse is enclosed in an insulating tube that confines the arc when the fuse blows and is available in either a ferrule or blade style.

A single-pole circuit breaker has one stab contact and a two-pole circuit breaker has two stab contacts.

All plug fuses are limited to circuits where the voltage between conductors does not exceed __________ volts. (General Rule)